Product Description:

This Rossmax non-contact temple thermometer is intended for measuring human body temperature; while is not intended as a substitute for consultation with your physician.

For non-contact temperature measurement - The advanced infrared temperature measuring technology provides safe, accurate, reliable and hygienic readings for measuring both forehead and ambient temperature. The forehead temperature reading lookup table was calculated and developed based on systematic skin clinical data statistics to accommodate fever and non-fever subjects, under different operating environment. The one second measurement thermometer without contacting skin is a suitable choice for obtaining body temperature and prevents cross contamination by measuring around 5 cm from the forehead.

Features:

• Measurement distance within 5cm (2 inch)
• 1 second measurement
• Temple temperature
• Object temperature
• Fever Alarm
• 9 memories
• °C / °F switchable
• Backlight
• Auto shut-off
• Low battery indicator
• Self-diagnosis for malfunction
  

Directions to Use:

How to measure temple temperature

1. Always make sure the probe is clean, and without damage.
2. Press “ON/OFF/Memory” button to power on the device.
3. Vertically aim the thermometer at the temple with a distance of less than 5 cm. If the temple is covered with hair, sweat or dirt, remove the obstacle from the temple to improve the measuring accuracy.
4. Press the “Start” button to take temperature. Measurement is complete when you hear a long beep sound.
5. Read the recorded temperature from the LCD display.
6. Clean the probe after each use to ensure an accurate reading and avoid cross contamination. ( See the section of Care and Cleaning for details.)
7. Remember to put in the storage case when not in use.
   

How to measure object temperature

When you want to measure object temperature, you have to change to Object Mode.

1. Make sure the device is turned off.
2. Hold down the “Start” button for about 8 seconds, and then the measuring site icon on the dis-play will be switched accordingly.
3. Release the “Start” button when the desired measurement mode is shown and 1 short beep sound will be heard.
4. When you are at Object Mode, press the “Start” button to get the real temperature.